We at Texora Painting & Drywall do wood rot and fascia repair in Tsawwassen, Ladner and the rest of Delta, BC. One of the two partners looks at the damage with you, one of our three uniformed crews repairs and paints it, and the written estimate names your 1, 2 or 3-year workmanship warranty.
Fascia boards, window sills, soffits, corner trim and the peaks of your roofline are usually the first places rot shows up, and left alone, a small soft spot turns into a bigger, more expensive problem. We repair minor exterior wood damage across Tsawwassen, Ladner and Delta.
As painters, we run into rotten and damaged wood constantly when prepping homes, so we handle the repair as part of the job: we replace or rebuild rotten fascia, fix weathered window sills, patch soffit and corner boards, and reseal the peaks and joints where water gets in.
Every repair is primed and painted to blend in. It pairs naturally with our exterior painting service, and every job starts with a free on-site look from one of the two partners and an honest written quote, with no obligation.
We fix the wood and finish it in one visit, so there's no waiting on a separate carpenter before your painters can start.
As painters, we spot rot and soft wood early and fix it right, so it doesn't come back through a fresh coat.
Proper sealing and priming keep moisture out of the repair through the Lower Mainland's wet winters.
Your home and our crew are protected on every job. 5-star rated with verifiable Google reviews.
The standard check is probing suspect wood with an awl or screwdriver at fascia edges, board ends, corner and peak joints, window sills, under drip edges, behind gutters and anywhere caulking has cracked, and if the tip sinks in without resistance, that section is compromised.
We probe suspect wood at fascia edges, board ends, joints, sills and behind gutters to find how far the rot runs.
Gutters, flashing, caulking and downspouts get checked so the cause is dealt with along with the wood.
Shallow damage is dug out and rebuilt with epoxy filler or consolidant, and deeper rot is cut out and spliced, or the board replaced.
New and repaired wood is primed on every surface, including cut ends and hidden sides.
Peaks and joints are resealed, and the repair is primed and painted to match the rest of your trim.
We walk the finished work with you before the job is done.
Featured Google reviews
“Great job painting our trim!”
“I was very pleased with Texora Painting. The owners and workers were very professional and worked to do an exceptional job. I really recommend them.”
“Excellent work, very professional. Entire exterior of our house look's like new. They kept to the schedule and completed in a timely fashion. Great price along with a great job. Well done and thanks for all your hard work. Shane”
“Did a great job with fashia repairs and preventive maintenance work!!”
Tino DeAngelis wrote this Google review in August 2026 about an exterior window and wood trim job.
“I found Texora painting very professional . I had an exterior window replaced and wood trim done.Very good with communication on when they arrive and what is going to be done. Very fair on the price, I would recommend them very highly.”
Replace rotten or damaged fascia boards, then prime and paint to match.
Repair or rebuild weathered, soft window sills and casings.
Fix and reseal the peaks, corners, and joints where rot starts.
Patch and replace damaged soffit boards and exterior trim.
Fix soft, rotten wood first so your exterior paint job lasts.
Proper filling, sanding, sealing, and priming for an invisible repair.
Exterior fascia and trim painting on Texora jobs
Painting exterior fascia and brushing window trim.
A small area of soft wood near the surface, with sound wood underneath, can usually be dug out and rebuilt with an epoxy wood filler or a two-part consolidant, then sanded and shaped to match the original profile. Once rot has worked through more of a board's thickness or travelled along the grain, filling is only a short-term fix, and the damaged length gets cut out and spliced, or the board replaced; your written estimate says which.
We prime new or repaired wood on every surface before it goes back on the house, including the ends and back that won't show, because end grain pulls in moisture far faster than the flat face and an unprimed cut end is often where the next round of rot starts.
Clogged or sagging gutters, missing flashing, failed caulking at a joint, or a downspout dumping water against a corner are the usual reasons fascia rots. If the water source isn't fixed, the new wood usually rots again.
Every job gets a final walkthrough, and if anything in the approved scope doesn't hold up to our own standard, we fix it as part of our satisfaction guarantee. Beyond that, our workmanship warranty runs one, two, or three years depending on the service and scope, and it's spelled out on your written estimate.
It covers failures caused by our own workmanship, things like peeling, blistering, or adhesion loss from improper prep or application. It does not cover new rot or moisture intrusion that shows up after the fact, normal wear and fading, building-envelope problems, or damage from something else entirely, like a gutter that fails two years later and lets water back in.
If you ever see a problem in an area we repaired, call us before anyone else touches it; see our warranty page for the full terms.
Tsawwassen has the Strait of Georgia on one side and Boundary Bay on the other, and steady sea air plus driving rain is enough to start rot on exterior wood that hasn't been checked in a while.
Wood repair and exterior painting go together on most jobs, and if it's brick you're dealing with instead of wood, our brick staining service covers that separately. Inside the house, walls, ceilings and trim are on our interior painting page.
| Damage | What we do | Then |
|---|---|---|
| Small soft area with sound wood underneath | Dug out and rebuilt with an epoxy wood filler or a two-part consolidant, then sanded and shaped to match the original profile | Primed on every surface, including cut ends and hidden sides, then painted to match the rest of your trim |
| Rot through more of the board, or along the grain | Filling is only a short-term fix, so the damaged length is cut out and spliced, or the board replaced; your written estimate says which | Primed on every surface, including cut ends and hidden sides, then painted to match the rest of your trim |
| The water source | Gutters, flashing, caulking and downspouts get checked so the cause is dealt with along with the wood | If the water source is not fixed, the new wood usually rots again |
Yes. We remove the affected boards, install new wood with primer on every surface, then paint to match the rest of your home's trim, often alongside an exterior repaint.
Yes. Rotten window sills, door casings, corner boards and other exterior trim are all repairable: depending on the damage we fill and rebuild the wood or replace the section, then finish it paint-ready.
Almost always. We fix the wood first (replace or fill, sand, then primer on every surface) so the finish lasts and the repair is invisible once painted.
We work in Ladner and Tsawwassen, across Delta, and in Coquitlam, Port Coquitlam and Port Moody. We are based at 1299 56 St in Tsawwassen, and Highway 17A, 56 Street and Ladner Trunk Road connect Tsawwassen with Ladner Village. In the Tri-Cities, Barnet Highway, Lougheed Highway and Ioco Road connect Port Coquitlam with Port Moody.
Read customer reviews or open the verified Texora Painting & Drywall business profile.
Open Texora's Google profileThe map is provided by Google Maps. Google may receive your IP address and use its own cookies.
We use cookies to improve your experience and understand our traffic. See our Privacy Policy & Cookie Policy.