We at Texora Painting & Drywall do drywall installation in Tsawwassen, BC, from Tsawwassen Springs townhomes to Beach Grove bungalows: basements, suites and main-floor renovations. We hang, tape and finish to a paint-ready standard, with moisture-resistant board where the coastal damp calls for it. 5.0 on Google from 50 reviews, with a 1, 2 or 3-year workmanship warranty.
Cost: priced from a visit to see the room and the framing in your Tsawwassen home, with the scope listed in your written estimate.
Paint after: we install, tape and finish the drywall, then prime and paint it as one job.
Below grade: moisture-resistant board in basements and damp rooms.
Texora Painting & Drywall installs and finishes drywall in Tsawwassen homes, from Tsawwassen Springs townhomes to Beach Grove bungalows, in the City of Delta, Metro Vancouver.
Texora Painting & Drywall is a painting and drywall contractor based at 1299 56 St in Delta, BC.
Texora Painting & Drywall has been BBB Accredited since 29 September 2026, with an A- rating.
Texora Painting & Drywall is the Quality Business Awards 2026 winner, Best Painters in Delta BC.
Drywall installation in Tsawwassen covers basement suites, additions and rooms after a kitchen or bathroom gut renovation. We at Texora Painting & Drywall supply, hang, tape, mud, sand and prime, so the space comes back ready for paint or wallcovering. Our Tsawwassen painters page lists the rest of the work we do in town.
The peninsula's high water table means Tsawwassen basements see more seasonal humidity than inland ones. Below-grade work gets moisture-resistant green or purple board, and wet areas get fibreglass mesh tape instead of paper tape to keep mould out of the joints.
Tsawwassen homes from the 1980s and 90s often have orange-peel or knockdown textures, and new drywall in a main-floor renovation or addition gets matched to them. Smooth Level 5 finishing is available for a flat-wall look.
Rolling an interior wall · Interior paintwork supplied by Texora.
What happens on a drywall installation day in Tsawwassen
Hanging the board is the fast part. Most of the timeline is the finishing after it: taping, several coats of mud with drying time between each, sanding and priming.
What to ask about dust and floor protection
Cutting sheets and sanding compound make a lot of dust. Before work starts, ask whether flooring gets covered along the path in, whether doorways into the room get sealed and whether anything stops a nearby HVAC return pulling dust through the ducts.
Interior brushwork · Interior paintwork supplied by Texora.
Featured Google reviews
Google reviews to read before hiring Texora in Tsawwassen
Rated 5.0 on Google
“Great company to deal with. Professional, detail-oriented and friendly. Came back for minor touch ups when asked without issue. Definitely recommend this company.”
Jenny, Google review, August 2026
“Absolutely amazing work! The attention to detail and professionalism really stood out, and the final result completely exceeded expectations”
Dominic Brayton, Google review, April 2026
“Excellent work. Personable and professional. I am very pleased and recommend their work,”
Barbara Helmer, Google review, September 2026
“Great friendly people easy to work with, I am very pleased with the patch and paint job the did to my bathroom. Looks fresh! Thank you! I will look to them for future projects.”
Taylor Watalla, Google review, September 2026Bathroom patch and paint
Book a visit at (604) 417-6483. One of our two partners checks the room and the framing in your Tsawwassen home, then you get a written estimate with the scope and a 1, 2 or 3-year workmanship warranty.
Renovating a house on Delta's Heritage Register? The City of Delta's heritage conservation page covers when a heritage alteration permit is needed.
How a drywall installation job runs in Tsawwassen
1
Measure and plan
We assess your space, confirm framing is plumb and square, identify moisture-sensitive zones, and provide a firm written quote covering all materials and labour.
2
Hang and fasten
Drywall sheets are cut to fit and fastened to framing using the correct screw pattern and spacing. Moisture-resistant board is installed wherever required.
3
Tape, mud and sand
Joints are taped, multiple coats of compound are applied and feathered, and the surface is sanded smooth. Inside corners, outside corners, and butt joints all receive proper treatment.
4
Prime and handoff
A coat of drywall primer is applied to seal the surface. We leave the space clean and paint-ready, or we continue straight into painting if booked together.
Interior paintwork
Interior wall painting and bathroom surfaces from Texora’s supplied photos.
Rolling an interior wallBathroom walls and trim
Drywall problems we see in Tsawwassen
Seasonal humidity in basements, from the peninsula's high water table; Metro Vancouver's wet season runs October to April.
Orange-peel or knockdown textures on 1980s and 90s homes that new drywall has to match.
Damp on walls next to the garage or the exterior, from the high water table and coastal humidity.
Condensation on north-facing walls of Tsawwassen homes, and indoor humidity in bathrooms and crawl spaces.
Ceiling drywall
A ceiling sheet is too heavy to hold by hand while it's fastened, so a panel lift or props keep it flat against the joists, and ceiling fasteners go closer together than on walls so the joints don't dip. For a ceiling that's already sagging or cracked, see our ceiling drywall repair page.
Tying new drywall into an existing wall or ceiling
Some older homes have half-inch drywall where a renovation calls for five-eighths, so the framing may need shimming to keep the new wall flush, and the seam gets feathered wider than a normal joint so no ridge shows. Texture is the other half, since Tsawwassen homes from the 1980s and 90s often have orange-peel or knockdown; see our texture matching and drywall taping and finishing pages.
Board thickness and fastener spacing
Half-inch board is standard on framing at sixteen inches, and five-eighths goes on ceilings with wider joist spacing or on fire-rated walls, such as the garage-to-house wall where the BC Building Code calls for 5/8" Type X. Screws go roughly every twelve inches on walls and closer on ceilings, biting the framing without breaking the paper face.
Getting your space ready before we install
Decide on outlet, switch and light locations before board goes up, since moving them afterward means cutting into finished work.
Confirm any plumbing, electrical or HVAC rough-in is inspected and signed off if your project requires it, since drywall typically goes up after that inspection.
What the workmanship warranty covers
Every installation comes with a 1, 2 or 3-year workmanship warranty, with the exact term stated on your written estimate. It covers problems that trace back to the work itself, like a taped joint that fails or a seam that cracks along its length, not settlement in the building, moisture intrusion from outside the wall, or damage from something unrelated happening afterward. If you notice anything off with a wall or ceiling we installed, call us before anyone else touches it so the work stays covered.
Board, fastening and finish for Tsawwassen installations
Area
Board
Fastening and tape
Finish
Basements and damp rooms
Moisture-resistant green or purple board, since the peninsula's high water table means Tsawwassen basements see more seasonal humidity
Fibreglass mesh tape instead of paper tape in wet areas, to keep mould out of the joints
Taped, mudded, sanded and primed, ready for paint or wallcovering
Walls on standard framing
Half-inch board on framing at sixteen inches
Screws roughly every twelve inches, biting the framing without breaking the paper face
Orange-peel or knockdown matched on 1980s and 90s homes; smooth Level 5 available for a flat-wall look
Ceilings
Five-eighths on ceilings with wider joist spacing
A panel lift or props hold the sheet flat against the joists; fasteners closer together than on walls so the joints don't dip
Same taping, mud coats and sanding, then drywall primer to seal the surface
Garage-to-house wall and other fire-rated walls
5/8" Type X, where the BC Building Code calls for it
The correct screw pattern and spacing
Primed and paint-ready
Tying into an existing wall
Five-eighths where the renovation calls for it, with the framing shimmed where the old wall is half-inch, to keep the new wall flush
The seam feathered wider than a normal joint so no ridge shows
Texture matched to the existing orange-peel or knockdown
Why Tsawwassen homeowners hire Texora for drywall installation
Board for coastal damp
In Tsawwassen's coastal damp, below-grade spaces get moisture-resistant board rather than standard drywall, and every other room gets the board it needs.
One contractor, start to finish
Because we also paint, drywall and painting happen under one roof with a single point of contact.
Per-room pricing
Drywall installation in Tsawwassen runs $800–$2,500 per room. We provide flat-rate quotes so you know the cost before we begin.
Texture matching
We replicate existing wall textures (orange peel, skip trowel, knockdown) so new areas blend into your Tsawwassen home's walls.
Other services in Tsawwassen
Interior painting
Once the drywall is done, our painting crew paints it, anywhere in your Tsawwassen home.
Drywall installation questions from Tsawwassen homeowners
Drywall installation in Tsawwassen typically costs $800–$2,500 per room depending on size, ceiling height, and finish level required. Contact us for a free, itemized estimate.
Yes. Due to Tsawwassen's high water table and coastal humidity, we strongly recommend moisture-resistant (green board or purple board) drywall for below-grade spaces and any walls adjacent to the garage or exterior, to reduce the risk of mould and delamination. In wet areas the joints get fibreglass mesh tape instead of paper tape.
Half-inch board is standard on framing at sixteen inches, and five-eighths goes on ceilings with wider joist spacing or fire-rated walls, such as one next to a garage. Some older Tsawwassen homes have half-inch where a renovation calls for five-eighths, so the framing may need shimming to keep the new wall flush.
In a Tsawwassen home, hanging the board is the fast part; most of the timeline is the finishing after it (taping, several coats of mud with drying time between each, sanding and priming), and your written estimate sets out the schedule.
Tsawwassen and nearby service areas
Public area maps for Tsawwassen, Ladner and Richmond.